1993-1995 Diagnostic Connectors (Check Engine)

1993-1995 Diagnostic Connectors Check Engine

From Bay 13

One of the best tools that you can buy is the "Pocket Data Booklet", TP 0302207, this 3 by 5 inch book contains all the codes plus all the various specifications, torque specs, it's just loaded with technical data that can be useful for maintaining your vehicle. 1-800-25-VOLVO, last listed price $15.95. To start, the Ignition key must be in position II, engine not running. Locate the two diagnostic sockets just inboard of the washer fill cap. The "A" connector (shown above) has a jumper that is stored in the lid of the "A" diagnostic connector. The jumper is used for both diagnostic connectors. Listed below is the information retrievable from the various connections.

A1 Transmission
B1 Climate Control
A2 Fuel System
B2 Cruise Control
A3 ABS
B5 SRS
A5 TCU (Transmission Control)
B6 Power Seat
A6 Ignition System
A7 Combined Instrument

Normally "Check Engine Light" information will be found in A2. Put the jumper into A2 and push the black button for one second. Count the red LED light as it blinks back information, blink, blink, pause, blink, blink, blink, pause, blink, blink, is an example of the response you would receive. 2-3-2 would be the code retrieved, now push the button again for one second, again count the blinks, keep checking for codes until one of them repeats, this means you have read all the codes. Now to clear the codes, push and hold the button for 6-7 seconds, release and as soon as the LED comes on push and hold the button for another 6-7 seconds. Now push the button for one second and read the codes again, you should get 1-1-1 (no faults). You Must Read All Codes before Clearing. Turn the ignition off and then start the car, the check engine light should be out. It is always a good idea to check for codes, clear them and then drive the vehicle to see if they return before replacing parts. The transmission can ask the check engine light to be turned on, so if you try clearing A2 codes and they wont go away try reading the transmission (A1), clear them , and then go back to A2.